Home/Answers/Masonry
CHIMNEY COST LAB / Masonry

How to Set Up Masonry

To set up Masonry, confirm the input format/device, choose output settings, then run a small batch.

Updated 2026-11-03About 3 minLocal test
Quick answer

To set up Masonry, confirm the input format/device, choose output settings, then run a small batch. Masonry depends on area/brick/mortar/scaffold.

Why it matters

Validate on a small sample before running the whole batch.

Area.

Step by step

  1. Check inspection/blockage/cracks/liner/leaks/use type.
  2. Separate sweep/repair/liner/crown/masonry/cap.
  3. Get 2-3 quotes; confirm scope/photos/warranty.
  4. Contract states scope/safety/payment/warranty.

Common mistakes

  • Sweep only, not liner/cracks inspection.
  • Not checking leaks/masonry/crown.
  • No photos/scope.
  • No warranty/payment terms.

Checklist

  • Inspection/blockage/cracks/liner/leaks.
  • Sweep/repair/liner/crown/masonry/cap.
  • Photos/scope/permits/safety.
  • Warranty/payment/contract.
  • Budget/maintenance/use type.

Who it is for

If this is your first Masonry, narrow by Area. and Brick. first, then look at specific models.

Key facts

  • Area.
  • Brick.
  • Scaffold.

FAQ

How do I set up Masonry?

To set up Masonry, confirm the input format/device, choose output settings, then run a small batch. Masonry depends on area/brick/mortar/scaffold.

How long does it take?

Usually 1-3 minutes; for intermittent issues, run 30 seconds and retest elsewhere.

Is data uploaded?

Runs locally and does not upload video/audio; extensions may still read the page.

Source: NFPA